Mark Material Defect as Not Fixable#

MaterialDefect.MarkAsNotFixable

Overview#

This operation is used to classify a specific Material Defect as Not Fixable.

Setup#

No special setup is required other than to meet the preconditions of the transaction.

Preconditions#

• The Material exists and it is Active.
• The Material must have open defects (Open Defect Count must be higher than zero).

Sequence of Steps#

1. Open the Material and navigate to the Defects view.
2. Select a Material Defect from the Defects panel on the left side of the screen.
3. Select the Mark as Not Fixable button on the top ribbon.
4. Select the Scrap Reason for the Material.
5. Verify the information and enter a Closing Remark if needed.
6. Select the Mark as Not Fixable button to complete the operation.