Record Assembled Material Loss/Bonus#

Material.RecordAssembledLossBonus

Overview#

The user accesses the system in order to record an assembled quantity loss or bonus for the Material.

Setup#

No special setup is required other than to meet the preconditions of the transaction. Note that the Loss and Bonus Reason(s) for Assemble must be associated with the current Material Step and that the Material must have been previously assembled.

Preconditions#

• Material exists, is Active and is not InTransit.
• Used Loss/Bonus Reasons are the ones which are defined for the current Material Step and which are applicable to Record Loss.
• If Material current Step IsDecimalQuantityAllowed is set to true, the user can specify decimal quantity losses, otherwise they must be integer.
• When reporting a Loss, the Material has a PrimaryQuantity or SecondaryQuantity greater than zero.
• There is a BOM defined for the topmost of the Material on which losses or bonuses are to be recorded.
• To record losses, the Material AssembledQuantity must be greater than zero.
• To record bonuses in a Material, its Topmost Material must have an AssemblyType different from AutomaticAtTrackOut in the associated BOM.
• For each selected Loss/Bonus Reason, either PrimaryQuantityLoss(Bonus) or SecondaryQuantityLoss(Bonus) are greater than zero.
• If recording bonus for a Material, since it is assumed that the bonus quantity will reside at the same container/position as the Material, it must be checked that, if a Container Position is defined for the Material, then the Container CapacityPerPosition can hold the Material plus the additional bonus quantity (Primary or Secondary Quantity as defined in the Container CapacityUnits).
• To record losses, if the Package Count is greater that zero, this operation can only be called from Terminate Package.

Sequence of Steps#

Step 1#

This screen captures all the information necessary to complete the transaction.

1. Verify the Material information.
2. Check the Terminate Material on zero quantities and no SubMaterials to terminate the Material automatically if it meets that criteria.
3. It is possible to set the Material final quantity, in which case the delta will be shown and automatically calculated.
4. In case that there is a catalogue of losses associated, it is possible, clicking on the multimedia button to visually select the appropriate loss reason - pressing OK will automatically add it to the list.
5. For each loss and bonus reason (if existing) enter the amount of primary quantities for that loss / bonus code.
6. Optionally enter a comment.
7. Press Record Loss/Bonus to complete the operation.