Automatic Track-Out#

Overview#

This feature enables automatic material Track-Out off the MES Resource.

Behavior#

Handle Tracking messages PRODCOMPLETED and PCBCHECKOUTV.

Relevant Artifacts#

The table below describes the properties for this entity type:

How It Works#

Area Feature Checks#

• Resolves the MES Resource Name using FUJI_LineNameMachineNameModuleNo_.
• Checks if Areas' FUJINEXIM_maxNumberOfRetries is defined.

Feature Checks#

• Checks if FujiIsLastModule is set to true for the resource.
• Checks if UseFujiToTrackOut is defined for the received event.
• Checks if UseTrackOutOperation is defined:
  • If defined, uses the specified operation.
  • If not, defaults to ComplexTrackOut.

Material Operations#

Calls the DEE IoTMaterialOperation unless UseFujiToTrackOut is not set, in which case the DEE call is bypassed.

For PRODCOMPLETED events, as we don't receive a Material identification, we will use a FIFO queue stored in persistency. We will try to retrieve a valid material identification for a FUJINEXIM_maxNumberOfRetries amount of seconds.

Each Fuji Machine Module has its own queue, the previous Module will pass the Material ID to the next queue, until we reach the last Module where it will be deleted.

Assumptions#

SmartTable IoTMetadataDefinition is configured with the following entry for each station: