Unrelease Batch#

Batch.Unrelease

Overview#

This operation is used to Unrelease a previously released Batch. This is typically to correct situations where the Batch was released by mistake, or when you need to make corrections to the Batch composition.

Setup#

No specific setup is required other than to meet the precondition of the transaction.

Preconditions#

• The Batch exists in the system and is Active.
• If the Batch Load Mode is defined:
  • The Batch system state is Released.
  • If the Batch Load Start Mode is After Release, the Load State must be Not Loaded.
• If the Batch Load Mode is not defined:
  • The Batch system state is Queued.
  • The Batch Load Mode is Loaded.

Sequence of Steps#

1. Choose a Released Batch, then select the Unrelease button on the top ribbon.
2. Optionally, enter a comment for the operation.
3. Select Unrelease Batch.