Skip to content

Mark Material Defect as False#

🔒 MaterialDefect.MarkAsFalse

Overview#

This operation is used to classify a specific Material Defect as False.

Setup#

No special setup is required other than to meet the preconditions of the transaction.

Preconditions#

  • The Material exists and it is Active.
  • The Material must have open defects (Open Defect Count must be higher than zero).

Sequence of Steps#

  1. Open the Material and navigate to the Defects view.
  2. Select a Material Defect from the Defects panel on the left side of the screen.
  3. Select the Mark as False button on the top ribbon.
  4. Verify the information and enter a Closing Remark if needed.
  5. Select the Mark as False button to complete the operation.

Sequence of Steps — 5. Select the Mark as False button to complete the operation